Simple Scud
The Simple Scud is an easy-to-tie imitation of freshwater scuds that works well for trout in both lakes and streams, especially on overcast days. Tied on a curved emerger hook with Sow Scud dubbing for the body, antennae, and legs, plus a Thin Skin shell and gold wire rib, it can be varied in colors such as tan and gray to match local scuds. It is typically fished subsurface and is effective wherever scuds are present.
Source: tightlinevideo
No photos of this fly yet
Tied the Simple Scud? Be the first to share a photo — it'll be featured right here.
Recipe
This page contains affiliate links. If you purchase through them, we may earn a small commission at no extra cost to you.
-
Hook · Standard emerger hook (Daiichi 1130 or similar), sizes 12-18
-
Thread · Light olive 70 denier or 8/0 UTC
-
Antennae · Smoky olive Sow Scud dubbing
-
Rib · Small gold Ultra Wire
-
Back · Tan and black fly speck Thin Skin
-
Body and legs · Smoky olive Sow Scud dubbing
Tying Instructions
-
1
Start the light olive thread about one-third of the way down the size 16 Dai-Riki 125 hook and take wraps well down the bend before returning to about halfway between the hook point and the barb.
-
2
Pull a thin wisp of smoky olive Sow Scud dubbing, snip one end close, and secure it with a pinch wrap so the fibers trail down the bend as antennae, then trim them to length.
-
3
Attach one end of the small gold Ultra Wire to the top of the hook shank and secure it with thread wraps down the bend.
-
4
Secure one end of a 1/8-inch strip of tan and black fly speck Thin Skin leaving about a sixteenth of an inch behind the eye, then wrap the thread rearward while keeping the strip centered on top of the shank.
-
5
Form a dubbing noodle about three inches long of the same smoky olive dubbing (optionally with a hint of orange in the middle) and wrap it forward from the tail to create a plump body tapered at both ends.
-
6
Pull the Thin Skin forward over the body, secure it with two or three wraps, then make two or three jam wraps in front of it and snip the excess close.
-
7
Make open spiral wraps of the Ultra Wire forward with firm pressure to segment the body, secure the wire with tight thread wraps, and helicopter it off cleanly.
-
8
Whip finish a small head, trim the thread, apply a drop of head cement, then tease out the dubbing fibers with a brush and trim them to about a hook gap in length to form the legs.