RS2

This is Charlie Craven’s synthetic variation of Rim Chung’s classic RS2, a highly effective Colorado emerger pattern long associated with the South Platte River. Tied in sizes 16–24 with white microfib tails, gray Super Fine dubbing, and a short white Antron wing, it is a confidence fly that has accounted for large numbers of trout for guides and anglers. The all-synthetic materials make it durable and consistent, and it also works well in black, brown, and olive.

No photos of this fly yet

Tied the RS2? Be the first to share a photo — it'll be featured right here.

Add Your Photo

Recipe

This page contains affiliate links. If you purchase through them, we may earn a small commission at no extra cost to you.

Tying Instructions

  1. 1

    Flatten the gray UNI 8/0 thread and start it about two eye lengths back from the hook eye, leaving a few inches of tag end that twists to the top as you wrap back to the bend.

  2. 2

    Take two white microfib tailing fibers with even tips, measure them about a shank length, angle them across the hook, and secure them with soft wraps so they roll to the top.

  3. 3

    Separate the tails to about 45 degrees with your thumbnail, pull the tag end up between them to spread them, and tie the tag down.

  4. 4

    Wrap forward over the tails and tag, trim the butts, then apply a very thin layer of gray Super Fine dubbing starting with a turn behind the tails to lift them and building a tapered abdomen up to the 80 percent point.

  5. 5

    Build a thread base to the eye and back to the front of the abdomen.

  6. 6

    Cut a whole strand of bright white Antron yarn square, melt the ends together, then pinch-wrap it in at the front edge of the body so the ends hang down behind the hook and wrap forward over them.

  7. 7

    Dub a small amount of gray Super Fine to form a rounded thorax up to the eye.

  8. 8

    Whip finish, then pull the wing forward over the hook eye and trim it square just past the eye for a short stub wing.