Intruder

This is a sparse, single-station Intruder-style steelhead fly designed primarily for winter fishing. Built on a Waddington shank with a trailing stinger hook, it uses a pink Ice Dub rear station, opal tinsel body, Arctic fox shoulder, and ostrich-and-flash wing to create a large profile and strong movement with minimal bulk. The open construction and light weight allow it to fish effectively on the swing while remaining easy to cast.

No photos of this fly yet

Tied the Intruder? Be the first to share a photo — it'll be featured right here.

Add Your Photo

Recipe

This page contains affiliate links. If you purchase through them, we may earn a small commission at no extra cost to you.

Tying Instructions

  1. 1

    Secure a 35 mm Partridge Waddington shank in the vise and lay a base of black 140 denier thread.

  2. 2

    Form a stinger loop of doubled 14 lb Fireline, attach a Partridge Z4 Intruder size 4 hook so the loop rides straight, and set the hook about one shank length behind the Waddington.

  3. 3

    Attach lead dumbbell eyes near the front of the upturned eye of the shank.

  4. 4

    Form a dubbing loop, load it with pink Ice Dub, spin it, and wrap it rearward while stroking the fibers back to create a bright rear station that protects the hook.

  5. 5

    Advance the thread halfway up the shank, tie in large opal Mylar tinsel, and reinforce the stinger attachment with glue.

  6. 6

    Form a second dubbing loop, load it with cleaned blue Arctic fox fibers long enough to reach over the pink station, spin it, and wrap forward while brushing the fibers back to form the shoulder.

  7. 7

    Stack blue ostrich fibers and catch two or three strands with each wrap to form a sparse wing, then add a few strands of black flash on top.

  8. 8

    Tie in fine black marabou by the tip on top, fold it back, and palmer it forward to form a collar.

  9. 9

    Dub a small amount of Pseudo Seal around the eyes for coverage, whip finish, and apply a drop of glue to the head.